Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightNoiseLeakMisfire or rough idleVibration or shudderAir conditioning or heaterReduced brakingCorrosion or rust

Possible causes

Noise, 200074 records
Steering
Engine
Brakes
Heating and air conditioning
Body, doors and interior
Other
5Steering intermediate shaft clunk1Tire scrub noise on low speed turns (steering rod / centerlink installed backwards)4Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring1Accelerator Pedal: broken0Engine knock on cold start (carbon on piston)4.8L, 5.3L, 6.0L only0Oil pump pickup (screen) O-ring cut: engine tick / lifter noise4.8L, 5.3L, 6.0L only0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only3Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1500 only3Engine compartment noise with A/C on and A/C inoperative (auxiliary rear A/C: suction hose and compressor)2Rear door window inoperative (motor replacement)2Power Window: failed1Side access door noise (door check link replacement)2Tire recall (not the vehicle as built): Firestone Wilderness LE tread separation - recall 01T-0011500 only
10 causes not drawn
Causes with no correction stated (8)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Transmission and driveline
Locking Rear Differential (2)Rear Axle: failed (2)Transmission: failed (1)
Brakes
Brake Drum: failed (1)Brake Shoe: failed (1)
Exhaust and emissions
Exhaust Manifold Heat Shield: loose or misadjusted (1)
Steering
Tie Rod (1)
Audio and telematics
Tweeter Speaker: loose or misadjusted (1)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Noise, 2000

Candidate cause (the documents say what to do)

Steering intermediate shaft clunk

A clunking noise under the hood that can be felt in the steering wheel and/or steering column.

Intermediate steering shaft clunk noise or stick-slip.

What to do

  1. When properly lubricated, there should be 13 mm (1/2 inch) of grease showing on the shaft splines.
  2. Replace the upper intermediate steering shaft assembly.
  3. There are significant differences between the car and truck procedures: the lubricant is applied to a different part of the steering system and uses a different lubrication kit, 26098419.
  4. On the affected trucks, remove the intermediate steering shaft from the vehicle and remove the spacer clip.
  5. Apply the contents of the syringe supplied with the kit into the open end of the fully-extended intermediate shaft.
  6. Insert the plug into the opening and tighten the wing nut.
Read the remaining 2 steps

What is needed

Parts and materials
  • Upper intermediate steering shaft assembly
  • Lubrication kit 26098419 (for trucks; different from the car kit)

Part numbers printed in the document

The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.

Labor time
Not stated
Special tools
Not stated
Scan tool
Not stated

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

  • Intermediate Steering Shaft: replaced 1
  • Steering Shaft: replaced 1（says it did not fix it: 1）
See the evidence (1 technical documents, 5 records)

Passages of the technical documents

  • A clunking noise under the hood that can be felt in the steering wheel and/or steering column.

    CLUNKING NOISE UNDER HOOD AND CAN BE FELT IN STEERING WHEEL AND/OR STEERING COLUMN

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2008-04-01

  • Replace the upper intermediate steering shaft assembly.

    (REPLACE UPPER INTERMEDIATE STEERING SHAFT [I-SHAFT] ASSEMBLY)

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2008-04-01

  • Intermediate steering shaft clunk noise or stick-slip.

    INTERMEDIATE STEERING SHAFT CLUNK NOISE OR STICK-SLIP (FOLLOW STRATEGY BASED DIAGNOSTICS).

    NHTSA manufacturer-communications index (NHTSA's one-line summary of a GM bulletin; not the bulletin text) 2006-02-01

  • The condition is covered in bulletin 00-02-35-003A and applies to 1999-2002 C/K pickup and utility models with recirculating ball steering.

    The condition covered here is found in bulletin 00-02-35-003A, and applies to 1999- 2002 C/K pickup and utility models with recirculating ball steering.

    General Motors 2002-04-01

Read every statement and its source →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.