GMC Yukon 2000–2006
Common on this vehicle:Warning light
Record by record
2 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.
How it is said to have ended
- says it came back1
- says it did not fix it1
- result not stated1
A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.
Read the records one by one (2)
ELECTRICAL SYSTEM1
Owner complaint2004 GMC YUKON ・ 2005-07-12
Brakes engaged without driver input after stability system disabled message
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- "STABILITY SYSTEM DISABLED" WAS DISPLAYED PRIOR TO THE BRAKES BEING ENGAGED WITHOUT DRIVER INPUT.
- Remedy
- THE VEHICLE WAS TAKEN TO THE DEALER AND A 'YAW SENSOR' REPLACED. (1 more)
SERVICE BRAKES, HYDRAULIC1
Owner complaint2004 GMC YUKON DENALI ・ 2008-11-12
Traction control message after stop, vehicle sluggish to accelerate
1Fault
2Finding the cause
Not stated
3Correction
Read the sentences of the record
- Fault
- 2004 GMC YUKON DENALI - TRACTION CONTROL MESSAGE COMES ON AFTER A STOP WHEN YOU START TO GO AGAIN AND IT FEELS LIKE THE VEHICLE DOES NOT WANT TO GO.
- Inspection
- WE HAVE TAKEN IT IN SEVERAL TIMES FOR THIS ISSUE BUT COULD NOT FIGURE OUT WHAT IT WAS DUE TO NO CODE IN THE COMPUTER.

