Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:

issueBench seat (RPO AE7) center console armrest hinges broken (replace the lid, not the console assembly)Remove

Possible causes

Stability control message (StabiliTrak)0 records
Brakes
0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)
Causes with no correction stated (2)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Electrical, wiring and power
Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
Brakes
Service Stability message with DTC C0131, C0196, C0290 and/or C0292 (0)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Stability control message (StabiliTrak)

Candidate cause (the documents say what to do)

Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)

Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.

The concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).

How to tell

C0455Stability control message (StabiliTrak)

What to do

  1. Remove the SWPS connector and inspect for bent terminals.
  2. In most cases the terminals can be straightened without replacing the sensor.

What is needed

Parts and materials
Not stated
Labor time
Not stated
Special tools
Not stated
Scan tool
Not stated

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

No record states work done for this cause.

See the evidence (1 technical documents, 0 records)

Passages of the technical documents

  • Applies to 2005 Cadillac, Chevrolet and GMC Full Size Utilities with RPO JL4.

    This information applies to 2005 Cadillac, Chevrolet, and GMC Full Size Utilities with RPO JL4.

    General Motors 2005-07-01

  • Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.

    Owners may comment on a Stability System Disabled or Service Stability message with DTC C0455.

    General Motors 2005-07-01

  • The concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).

    This concern may be caused by bent terminals on the SWPS (Steering Wheel Position Sensor).

    General Motors 2005-07-01

  • Remove the SWPS connector and inspect for bent terminals.

    Remove the SWPS connector and inspect for bent terminals.

    General Motors 2005-07-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 0 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.