Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightLoss of engine power, no acceleration

Record by record

8 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (7)

Known issuesDTCs P2108, P1516 and U0107 (do not replace the TAC module)1

  1. Manufacturer communication2006 GMC YUKON ・ 2007-01-25

    LR4, LY2, L33, LH6, LM7, L59, LC9, LMG, LY5, LS2, LQ9, LQ4, L76, LY6 Throttle Actuator Control Module Communication

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      LR4, LY2, L33, LH6, LM7, L59, LC9, LMG, LY5, LS2, LQ9, LQ4, L76, LY6 THROTTLE ACTUATOR CONTROL (TAC). MODULE CODES, MIL/SES DTC'S P2108, P1516, U0107, REDUCED ENGINE POWER. *KB

      What the documents say to do

      DTCs P2108, P1516 and U0107 (do not replace the TAC module)

      Confirm

      • Perform the diagnostics for the DTCs, but delete the steps that involve replacing the TAC module.

      Caution

      • Do not replace the TAC module; the reference given is PIP 3812A.
    Read the sentences of the record
    Remedy
    LR4, LY2, L33, LH6, LM7, L59, LC9, LMG, LY5, LS2, LQ9, LQ4, L76, LY6 THROTTLE ACTUATOR CONTROL (TAC). MODULE CODES, MIL/SES DTC'S P2108, P1516, U0107, REDUCED ENGINE POWER. *KB

ENGINE AND ENGINE COOLING4

  1. Manufacturer communication2003 GMC YUKON ・ 2004-09-27

    Service Engine Soon light and reduced engine power mode

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SERVICE ENGINE SOON LIGHT AND / OR REDUCED ENGINE POWER MODE DUE TO DIAGNOSTIC TROUBLE CODES P0120, P0220, P1516 AND/OR P1518. THIS CONDITION IS NORMALLY VERY INTERMITTENT. *TT

    Read the sentences of the record
    Remedy
    SERVICE ENGINE SOON LIGHT AND / OR REDUCED ENGINE POWER MODE DUE TO DIAGNOSTIC TROUBLE CODES P0120, P0220, P1516 AND/OR P1518. THIS CONDITION IS NORMALLY VERY INTERMITTENT. *TT

  2. Manufacturer communication2003 GMC YUKON ・ 2004-09-27

    SERVICE ENGINE SOON Light and Reduced Engine Power Mode

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SERVICE ENGINE SOON LIGHT AND / OR REDUCED ENGINE POWER MODE DUE TO DIAGNOSTIC TROUBLE CODES P0120, P0220, P1516 AND/OR P1518. THIS CONDITION IS NORMALLY VERY INTERMITTENT. *TT

    Read the sentences of the record
    Remedy
    SERVICE ENGINE SOON LIGHT AND / OR REDUCED ENGINE POWER MODE DUE TO DIAGNOSTIC TROUBLE CODES P0120, P0220, P1516 AND/OR P1518. THIS CONDITION IS NORMALLY VERY INTERMITTENT. *TT

  3. Manufacturer communication2003 GMC YUKON DENALI ・ 2003-11-24

    Service Engine Soon Light On with TAC Module Codes

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      SERVICE ENGINE SOON (SES) LIGHT ON WITH TAC MODULE CODES P1516 AND POSSIBLE CODES P1514, P1515, P1518. *TT

    Read the sentences of the record
    Remedy
    SERVICE ENGINE SOON (SES) LIGHT ON WITH TAC MODULE CODES P1516 AND POSSIBLE CODES P1514, P1515, P1518. *TT

  4. Manufacturer communication2003 GMC YUKON ・ 2003-09-29

    Check Engine Light With DTC P0120, P0220, P1516, P1518

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      CHECK ENGINE LIGHT ON WITH NO DRIVABILITY CONCERNS, DIAGNOSTIC TROUBLE CODE P0120, P0220, P1516, OR P1518 SET. *TT

    Read the sentences of the record
    Remedy
    CHECK ENGINE LIGHT ON WITH NO DRIVABILITY CONCERNS, DIAGNOSTIC TROUBLE CODE P0120, P0220, P1516, OR P1518 SET. *TT

ELECTRICAL SYSTEM2

  1. Manufacturer communication2005–2006 GMC YUKON DENALI ・ 2018-05-21(1 earlier editions of this document folded here)

    Throttle Position Sensor Cover Replacement

    1. 1Fault

      • The malfunction indicator lamp (MIL) is illuminated with a Reduced Engine Power message displayed.
      • A scan tool may show DTC P2135: Throttle Position (TP) Sensor 1-2 Correlation set as Current or in History.

    2. 2Finding the cause

      Possible causes

      • The condition may be caused by the difference between TP Sensor 1 and TP Sensor 2 exceeding a calibrated value for more than 2 seconds.

      Steps to confirm (in the document’s order)

      1. After installing the new cover, if the scan tool TP Sensor 1 and 2 Agree/Disagree parameter displays Disagree, replace the throttle body assembly.
      2. If DTC P1516, P2101 and/or P2176 are set, replace the throttle body.

    3. 3Correction

      Repair

      1. Clean the throttle body bore and throttle plate with a clean shop towel and GM Top Engine Cleaner, P/N 1052626 (in Canada, P/N 993026), or ACDelco Upper Engine and Fuel Injector Cleaner, P/N 88861803, or an equivalent product.
      2. Remove the old TP sensor cover from the throttle body: grasp the cover, carefully lift it up and separate it from the throttle body.
      3. Tighten the throttle body fasteners to 89 lb in (= 10.1 N·m) (the text prints the metric value as "10 Y").
      4. Reprogram the ECM using the Service Programming System (SPS) with the latest calibration available on TIS2WEB.
      5. Perform the Throttle Learn Reset Procedure.

      Part numbers printed in the document

      The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.

      Parts

      • Part number 19259452, Throttle Position (TP) Sensor Cover, quantity 1.

      Part numbers printed in the document

      The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.

      Caution

      • Do not replace the throttle body; follow the procedure in the bulletin instead.
      • If the throttle body is dropped at any time during the procedure, abort the procedure and replace it with a new throttle body assembly.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：The Yukon entries are 2008-2011 GMC Canyon, Savana, Sierra, Sierra Denali and Yukon models (note: earlier Yukon model years are not listed).
    • Condition：The malfunction indicator lamp (MIL) is illuminated with a Reduced Engine Power message displayed.
    • Condition：A scan tool may show DTC P2135: Throttle Position (TP) Sensor 1-2 Correlation set as Current or in History.
    • Cause：The condition may be caused by the difference between TP Sensor 1 and TP Sensor 2 exceeding a calibrated value for more than 2 seconds.
    • Caution：Do not replace the throttle body; follow the procedure in the bulletin instead.
    • Repair：Clean the throttle body bore and throttle plate with a clean shop towel and GM Top Engine Cleaner, P/N 1052626 (in Canada, P/N 993026), or ACDelco Upper Engine and Fuel Injector Cleaner, P/N 88861803, or an equivalent product.
    • Repair：Remove the old TP sensor cover from the throttle body: grasp the cover, carefully lift it up and separate it from the throttle body.
    • Caution：If the throttle body is dropped at any time during the procedure, abort the procedure and replace it with a new throttle body assembly.
    • Confirm：After installing the new cover, if the scan tool TP Sensor 1 and 2 Agree/Disagree parameter displays Disagree, replace the throttle body assembly.
    • Confirm：If DTC P1516, P2101 and/or P2176 are set, replace the throttle body.
    • Repair：Tighten the throttle body fasteners to 89 lb in (= 10.1 N·m) (the text prints the metric value as "10 Y").
    • Repair：Reprogram the ECM using the Service Programming System (SPS) with the latest calibration available on TIS2WEB.
    • Repair：Perform the Throttle Learn Reset Procedure.
    • Parts：Part number 19259452, Throttle Position (TP) Sensor Cover, quantity 1.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This technical bulletin provides a procedure for replacing the throttle position sensor cover for concerns regarding a indicator lamp illuminated reduced power message displayed and DTC P2135 set.

  2. Manufacturer communication2003–2006 GMC YUKON ・ 2004-10-04

    Service Engine Soon Light and Reduced Engine Power (P1516)

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SERVICE ENGINE SOON LIGHT AND REDUCED ENGINE POWER WITH A DIAGNOSTIC TROUBLE CODE P1516. DIAGNOSTIC TROUBLE CODES P0120, P0220, P1514, P1515, P1518 AND P2135 MAY ALSO BE PRESENT. *TT

    Read the sentences of the record
    Remedy
    SERVICE ENGINE SOON LIGHT AND REDUCED ENGINE POWER WITH A DIAGNOSTIC TROUBLE CODE P1516. DIAGNOSTIC TROUBLE CODES P0120, P0220, P1514, P1515, P1518 AND P2135 MAY ALSO BE PRESENT. *TT

Showing 7 of the 8 you can open. Narrow the search to see the rest.