Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning light

Possible causes

Warning light, C07114 records
Suspension, wheels and tires
Brakes
Transmission and driveline
Electrical, wiring and power
Engine
Exhaust and emissions
2Autoride (Z55) Service Ride Control / Service Suspension System message0Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1060Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5210Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)
7 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Autoride (Z55) Service Ride Control / Service Suspension System message

On 2009 or earlier vehicles a Service Suspension System message may appear and the rear ride height may be incorrect.

The Electronic Suspension Control module will have DTC C0696 or C0711 set.

How to tell

C0580C0696C0711Service Ride Control / suspension message

What to do

  1. The compressor assembly may need to be removed to see whether the wiring is pinched between the compressor and the frame.
  2. The module checks level-system pressure at start-up and runs the compressor to add air to the shocks if it is below 10 psi (69 kPa).
  3. Repair the damaged or shorted circuits and reposition the wiring so it is not damaged again when the compressor is installed.
  4. The sensor is not serviced separately; install a complete air filter, dryer and sensor assembly.
  5. For a Service Ride Control message with DTC C0580, replace the right front shock absorber solenoid connector and install new A/C suction and auxiliary evaporator hoses.
  6. The jumper harness is included with the complete air filter, dryer, and sensor assembly PN 22964558; vehicles built in May, 2012 and later do not require the jumper harness and use PN 22941807.
Read the remaining 1 steps

Caution: Do not replace the complete air compressor assembly for this concern.

Part numbers printed in the document

The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.

In the records

  • Air Compressor: repaired 1
  • Air Filter Dryer and Sensor Assembly: replaced 1
  • Auto Leveling Compressor Air Inlet Filter and Hose Assembly: replaced 1
See the evidence (1 technical documents, 2 records)

Passages of the technical documents

  • 2001-2013 GMC Yukon, Yukon XL LD, Yukon Denali, Yukon Denali XL With RPO Z55 or Z95

    General Motors (filed with NHTSA as SB-10052488) 2013-06-01

  • Some customers of 2009 or prior vehicles, may comment of a Service Suspension System message on the DIC and the rear suspension ride height is incorrect.

    General Motors (filed with NHTSA as SB-10052488) 2013-06-01

  • When checking for DTCs the Electronic Suspension Control (ESC) module will have DTC C0696 or C0711 set.

    General Motors (filed with NHTSA as SB-10052488) 2013-06-01

  • This concern could be caused by the wiring to the automatic level control (ALC) pressure sensor being shorted to ground, as shown below.

    General Motors (filed with NHTSA as SB-10052488) 2013-06-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 2 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.