Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:Does not startStalls or shuts off

issuePasslock theft deterrent: starts then stalls / no-start with security lampRemove

Record by record

2 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Read the records one by one (2)

Known issuesPasslock theft deterrent: starts then stalls / no-start with security lamp2

  1. Manufacturer communication2000–2001 GMC YUKON ・ 2001-11-19

    Security Lamp and Engine Stall Issues with DTC B2960

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      INFORMATION REGARDING SECURITY LAMP ILLUMINATING ON THE INSTRUMENT PANEL, ENGINE STALL, NO START, AND DIAGNOSIC TROUBLE CODE B2960. *SLC

      What the documents say to do

      Passlock theft deterrent: starts then stalls / no-start with security lamp

      Confirm

      • A security lamp flashing after an attempted start means the fuel disable command is active.

      Repair

      • The condition is the Security lamp illuminated on the instrument panel, engine stalls or no start, with DTC B2960 (Security System Sensor Data Incorrect but Valid) set; the correction is to inspect and repair the cause of DTC B2960.

      Caution

      • Loss of Ignition 1 voltage to the BCM gives the same start-then-stall behaviour.
    Read the sentences of the record
    Remedy
    INFORMATION REGARDING SECURITY LAMP ILLUMINATING ON THE INSTRUMENT PANEL, ENGINE STALL, NO START, AND DIAGNOSIC TROUBLE CODE B2960. *SLC
  2. Manufacturer communication2000–2001 GMC YUKON ・ 2001-10-26

    Security Lamp and Engine Stall Condition – DTC B2960

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      SOME VEHICLES MAY EXHIBIT A SECURITY LAMP ILLUMINATED ON THE INSTRUMENT PANEL, ENGINE STALL, NO START CONDITION, AND DIAGNOSTIC TROUBLE CODE B2960. *TT

      What the documents say to do

      Passlock theft deterrent: starts then stalls / no-start with security lamp

      Confirm

      • A security lamp flashing after an attempted start means the fuel disable command is active.

      Repair

      • The condition is the Security lamp illuminated on the instrument panel, engine stalls or no start, with DTC B2960 (Security System Sensor Data Incorrect but Valid) set; the correction is to inspect and repair the cause of DTC B2960.

      Caution

      • Loss of Ignition 1 voltage to the BCM gives the same start-then-stall behaviour.
    Read the sentences of the record
    Remedy
    SOME VEHICLES MAY EXHIBIT A SECURITY LAMP ILLUMINATED ON THE INSTRUMENT PANEL, ENGINE STALL, NO START CONDITION, AND DIAGNOSTIC TROUBLE CODE B2960. *TT