Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning light

Possible causes

Warning light, B24552 records
Electrical, wiring and power
Audio and telematics
Brakes
Transmission and driveline
Engine
Exhaust and emissions
1Vehicle Communication Interface Module0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Reduced Engine Power from throttle body connector crimp, broken wire or grounds1Red OnStar LED and DTC B2455 after Canada upgrade bulletin 15-08-44-001 (audio and microphone drain wires shorted)0Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)0Transfer case service light, New Venture Gear transfer case (replace the encoder motor sensor and reprogram the TCCM)0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5210Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)
9 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Vehicle Communication Interface Module

1 of the records matching this search name this component as the cause. How it failed: electrical fault.

How to tell

B2455

What to do

  1. Pull back the tape at X2 of the VCIM far enough to see where the bare wires are covered.
  2. Tape the bare wires individually to prevent them from shorting, then tape the harness back up.
  3. The warranty labor operation is 602058, Onstar Upgrade Wire Repair.

In the records

  • Vehicle Communication Interface Module: repaired 1
See the evidence (1 technical documents, 1 records)

Manufacturer’s documents

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.