GMC Yukon 2000–2006
Common on this vehicle:Warning lightNoiseLoss of engine power, no accelerationMisfire or rough idleLeakGauge or instrument faultStalls or shuts offDoes not start
Possible causes
10 causes not drawn
- Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only1
- DTCs P2108, P1516 and U0107 (do not replace the TAC module)1
- P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1
- Oil leak after cold start from frozen PCV system (rear main seal)1
- Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only1
- Slight roughness at idle with no DTCs (possible characteristic)1
- Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)1
- Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1
- Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1500 only1
- Seat: broken1
Causes with no correction stated (19)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
- Exhaust and emissions
- Exhaust Manifold Bolt: broken (8)Evap Vent Valve: clogged or contaminated (1)Secondary Air Injection Valve: corroded (1)
- Other
- Bolt: broken (2)
- Fuel system
- Fuel Injector: clogged or contaminated, corroded (2)Fuel Tank Cap: loose or misadjusted (1)
- Electrical, wiring and power
- TAC Module: electrical fault, failed (2)Body Control Module: failed (1)Junction Box: failed (1)Starter: failed (1)
- Instruments and lighting
- Ambient Light Sensor: loose or misadjusted (1)Daytime Running Light Bulb: failed (1)Headlight: loose or misadjusted (1)
- Heating and air conditioning
- Blower Motor: failed (1)Blower Motor Control Module: failed (1)
- Transmission and driveline
- Needle Bearing: failed (1)Rear Axle: failed (1)Transmission Seal: failed (1)
- Cooling
- Radiator Seal: failed (1)
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・Engine
Candidate cause (the documents say what to do)
Exhaust pop or ping noise (replace the heat shield, not the exhaust system)
2 of the records matching this search name this component as the cause.
What to do
- Replace the heat shield.
Caution: Do not replace the exhaust system. The reference bulletin is 03-06-05-008B.
What is needed
- Parts and materials
- Heat shield
- Labor time
- Not stated
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
No record states work done for this cause.
See the evidence (1 technical documents, 2 records)
Passages of the technical documents
2002-2005 Tahoe, Suburban, All Yukons, All Escalades, Avalanche, H2: an exhaust pop or ping noise.
2002-2005 Tahoe, Suburban, All Yukons, All Escalades, Avalanche, H2 – Exhaust Pop/Ping Noise
General Motors 2005-03-01
Replace the heat shield.
Replace heat shield.
General Motors 2005-03-01
Do not replace the exhaust system. The reference bulletin is 03-06-05-008B.
Don’t replace exhaust system. 03-06-05-008B
General Motors 2005-03-01
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.