Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
Add conditions (optional: symptom, model year, system, warning display, trouble code, kind of record)

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Corrosion or rustLeakNoiseReduced brakingAir conditioning or heaterParking brakeLoss of engine power, no acceleration

causeHub AssemblyRemove

Record by record

10 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

Work done

How it is said to have ended

  • result not stated4

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (10)

Known issuesUnwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1

  1. Owner complaint2002 GMC YUKON ・ 2005-10-20

    ABS sensors replacement needed

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Remedy
    THE CONSUMER HAD TO HAVE ABS SENSORS REPLACED. (1 more)
    Inspection
    MECHANIC TESTED THE SENSORS AND STATED THIS WOULD NOT STOP VEHICLE.*AK THE FRONT HUB AND BEARING WERE CORRODED ALONG WITH THE SENSORS.

Known issuesGrease seen at front hub bearing seals (normal purge, do not replace)1

  1. Manufacturer communication2004–2006 GMC YUKON DENALI ・ 2017-08-15

    Front hub bearing grease leakage preliminary information

    1. 1Fault

      • Grease may move radially outward from the bearing seal area onto adjoining components.

    2. 2Finding the cause

      Possible causes

      • The factory grease fill of the front bearing/hub assembly is more than the bearing needs for lubrication over the life of the vehicle.
      • Part of the grease purges through the self-venting bearing seals during the initial drive period (a few thousand miles/kilometers) and helps form an extra barrier against contamination.

      Steps to confirm (in the document’s order)

      1. Replace the bearing if its endplay is greater than 0.005" or 0.13mm.
      2. Replace the bearing if the seals show visible damage.
      3. Replace the bearing if it rotates roughly.
      4. Replace the bearing if it makes abnormal noise.

    3. 3Correction

      Repair

      • If desired, grease that has migrated away from the immediate seal area can be wiped off.

      Caution

      • Do not replace the bearing for grease purge, and do not clean the purged grease on or right next to the seals, because it gives additional protection.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2004-2013 GMC Sierra, Sierra Classic, Yukon and Yukon Denali models (note: the Yukon years run later than the years this service covers).
    • Condition：Grease may move radially outward from the bearing seal area onto adjoining components.
    • Cause：The factory grease fill of the front bearing/hub assembly is more than the bearing needs for lubrication over the life of the vehicle.
    • Cause：Part of the grease purges through the self-venting bearing seals during the initial drive period (a few thousand miles/kilometers) and helps form an extra barrier against contamination.
    • Caution：Do not replace the bearing for grease purge, and do not clean the purged grease on or right next to the seals, because it gives additional protection.
    • Repair：If desired, grease that has migrated away from the immediate seal area can be wiped off.
    • Confirm：Replace the bearing if its endplay is greater than 0.005" or 0.13mm.
    • Confirm：Replace the bearing if the seals show visible damage.
    • Confirm：Replace the bearing if it rotates roughly.
    • Confirm：Replace the bearing if it makes abnormal noise.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This Preliminary Information communication provides information to the technician about vehicles that have grease leaking from front hub bearings. Technician should not replace the bearing for grease purge. Technician should be advised to not clean the purged grease from the area immediately on or adjacent to the seals because this grease provides additional protection. Technician should only replace the bearing if the seals show visible damage, bearing endplay is greater than 0.005" or 0.13mm, bearing exhibits rough rotation, or bearing exhibits abnormal noise.

Known issuesParking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)1

  1. Owner complaint2001 GMC YUKON DENALI ・ 2004-12-10

    Parking brake failure: no indication of function

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

      What the documents say to do

      Parking brake linings worn out prematurely, parking brake does not hold (PBR single-shoe drum-in-hat)

      Confirm

      • On complaint vehicles examined in the field, wear occurred earlier and to a greater extent on the driver's side parking brake unit and was largely localized at the tip of one of the linings.

      Repair

      1. A revised clip designed to exert less force on the shoe went into MY 2003 production and into the service part stream. Installing the newer clip and replacing worn linings has been shown to remedy the defect.
      2. The closing report lists a bulletin of Aug 2004 as 02-05-26-001B "Brakes - Parking Brake Shoe Retainer Clip Availability", announcing a new retainer clip service kit for DIH-equipped vehicles.

      Caution

      • The vehicles warn the operator with a chime if driven over 3 mph (= 4.83 km/h) with the parking brake engaged.
    Read the sentences of the record
    Fault
    THEY GIVES NO INDICATION THAT THE PARKING BRAKE IS WORKING BECAUSE THE PEDAL FEELS THE SAME, NO RESISTANCE, WHEN WORKING AND WHEN NOT.
    Cause
    PARKING BRAKE FAILURE: RESULTS FROM ONE TIME DRIVING OFF WITH THE PARKING BRAKE ON OR SIMPLY TOWING A TRAILER AND PARKING IT ON A HILL AND SETTING THE PARKING BRAKE.

SUSPENSION3

  1. Owner complaint2002 GMC YUKON ・ 2003-07-31

    Front and rear wheel bearings replacement required

    1. 1Fault

      Not stated

    2. 2Finding the cause

    3. 3Correction

      Not stated

  2. Owner complaint2001 GMC YUKON ・ 2003-05-22

    Wheel bearings and tires reported as needing service

    1. 1Fault

      Not stated

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Inspection
    THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHO STATED THE WHEEL BEARINGS WERE BAD AND THE VEHICLE ALSO NEEDED TIRES. *JB

  3. Owner complaint2000 GMC YUKON ・ 2001-12-13

    Wheel bearing failure at low mileage

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Inspection
    IT WAS MIS DIAGNOSED BY J.P. THIBODEAUX GMC IN NEW IBERIA, LA. (1 more)

AIR BAGS1

  1. Owner complaint2006 GMC YUKON ・ 2017-08-23

    Right front tire hub damaged, tire falling off, tire sensor warning, blower motor not working

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    MY TIRE IS IN THE MIDST OF FALLING OFF I CONTINUOUSLY GET A NOTICE TO CHECK TIRE SENSOR IN ADDITION I HAVE HAD SEVERAL ELECTRICAL ISSUES INCLUDING THE FAN NOT WORKING INSIDE THE VEHICLE TO TURN ON THE HEAT OR AIR CONDITIONER

ELECTRONIC STABILITY CONTROL (ESC)1

  1. Owner complaint2004 GMC YUKON DENALI ・ 2012-10-16

    Stability control disabled and reduced engine power warnings, then engine stalls while driving

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    WHILE IN THE MIDDLE OF DRIVING, THE "STABILITY CONTROL DISABLED" SENSOR COMES ON FOLLOWED BY "REDUCED ENGINE POWER" AND MY VEHICLE JUST SHUTS OFF.
    Remedy
    I HAVE ALREADY REPLACED A HUB THAT MY MECHANIC SAID WAS CAUSING A "TRACTION CONTROL" PROBLEM FROM EARLIER.

SERVICE BRAKES1

  1. Owner complaint2003 GMC YUKON ・ 2018-07-02

    Right front hub detachment and braking system failure

    1. 1Fault

      THE RIGHT FRONT DRIVERS SIDE HUBS WAS ABOUT TO COME OFF AND MY ENTIRE BRAKING SYSTEM WENT OUT WHILE DRIVING ON THE HIGHWAY.

    2. 2Finding the cause

    3. 3Correction

      Not stated

    Read the sentences of the record
    Fault
    THE RIGHT FRONT DRIVERS SIDE HUBS WAS ABOUT TO COME OFF AND MY ENTIRE BRAKING SYSTEM WENT OUT WHILE DRIVING ON THE HIGHWAY.

SERVICE BRAKES, HYDRAULIC1

  1. Owner complaint2002 GMC YUKON ・ 2005-11-30

    Front wheel assembly replacement on 2002 GMC Yukon

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Remedy
    2002 GMC YUKON FRONT WHEEL ASSEMBLY HAD TO BE REPLACED.

1 owner complaints have no classified sentences yet, so their causes and repairs are not picked out. Their text is in the list of records.