Manufacturer communication — 2006 GMC YUKON

• Applies to 2007-2013 GMC Yukon models and Yukon XL models (note: earlier Yukon model years are not listed).

  the passage

  2007-2013 GMC Yukon Models, Yukon XL Models

• Condition 1: a dimpling or deformation is seen near an outer edge of the liftgate center applique.

  the passage

  Some customers may comment on seeing a dimpling or deformation (shown circled above) near an outer edge of the liftgate center applique.

• Condition 2: paint damage on the liftgate at the lower outboard edges of the center applique.

  the passage

  Some customers may comment on paint damage (shown circled above) on the liftgate at the lower outboard edges of the center applique.

Possible causes

• The applique design might allow deformation or dimpling of its surface if the retaining nuts are overtightened.

  the passage

  The design of the applique might allow deformation or dimpling of the applique surface if the retaining nuts are overtightened.

• The applique design together with the forming of the license plate pocket in the liftgate may let the lower outboard edges of the applique contact the liftgate.

  the passage

  The design of the applique in conjunction with the forming of the license plate pocket in the liftgate may allow the lower outboard edges of the applique to have contact with the liftgate.

Repair

1. For 2011 or earlier vehicles, replace the liftgate center applique with the appropriate new service part from the table.

   the passage

   For 2011 or earlier vehicles, replace the liftgate center applique with the appropriate new service part listed in the table below.

2. To create clearance, add GM washer P/N 15911310 to the applique between the foam washer and the mounting boss at each of the four mounting stud locations.

   the passage

   Add GM washer P/N 15911310 to the applique between the foam washer (1) and the mounting boss (2) at each of the four mounting stud locations.

Parts

• P/N 15911310 is a 0.25 mm thick Mylar washer.

  the passage

  P/N 15911310 is a 0.25 mm thick Mylar washer.

• Applique 22777530 is for GMC non-hybrid without rear vision camera (-UVC).

  the passage

  22777530 APPLIQUE ASM-L/GATE CTR *"NO COLOR" GMC Non-Hybrid W/O Rr Vision Camera (-UVC)

• Applique 22777531 is for GMC non-hybrid with rear vision camera (&UVC).

  the passage

  22777531 APPLIQUE ASM-L/GATE CTR *"NO COLOR" GMC Non-Hybrid W/ Rr Vision Camera (&UVC)

Caution

• The updated applique design went into production for the 2012 model year; the applique should not need replacement on a 2012 or newer vehicle unless Condition 1 is present.

  the passage

  The updated applique design went into production for the 2012 model year. The applique should Not require replacement on a 2012 or newer vehicle, unless Condition 1 is present.